Bobcat 328 - S/N 234211001 Instructions d'exploitation télécharger pdf (Page 116)

325/328 Excavator

Operation and Maintenance Manual 94

DELUXE INSTRUMENT PANEL SETUP

Passwords

All new machines with Deluxe Instrumentation arrive at

Bobcat dealerships with the panel in locked mode. This

means that a password must be used to start the engine.

For security purposes, your dealer may change the

password and also set it in the locked mode. Your

dealer will provide you with the password.

Master Password:

A permanent, randomly selected password is set at

the factory which cannot be changed. This password

is used for service by the Bobcat dealer if the Owner

Password is not known; or to change the Owner

Password.

Owner Password:

There is only one Owner Password (CodE 0). It must

be used to change the owner or operator passwords.

See below for changing the Owner Password.

Operator Password:

There can be up to three operator Passwords

(CodE 1, CodE 2, CodE 3). See below for changing

the Operator Password.

Password Entry (For Starting and Operating the

Machine)

Press ENTER CODE button (Item 1). The panel will light

up and there will be two short beeps. CodE will appear on

the LCD (Item 2) [Figure SA-1].

NOTE: After you press ENTER CODE you have 40

seconds to use the keypad (Item 3)

[Figure SA-1] to enter the password. (If more

than 40 seconds is used, the process will abort

and you will need to start over.

Enter the password. For each digit that you enter, a dash

will appear on the LCD. If the password was entered

correctly, there will be one long beep.

NOTE: If the password was incorrect there will be

three short beeps and

Error

will appear on the

LCD. Press the ENTER CODE button again and

start over. After three failed attempts, you

must wait three minutes to try again.

You are now ready to start and operate the machine.

If you will be changing the operator password, do not start

the engine. (See Changing The Operator Password on

Page 94.)

Figure SA-1

Changing The Operator Password

Perform Password Entry at left, but do not

start the

engine.

Press and hold the ENTER CODE button (Item 1) for

three seconds. CodE 1 will appear on the LCD (Item 2)

[Figure SA-1].

Press the ENTER CODE button until the desired operator

Code (CodE 1, CodE 2, CodE 3) appears. You now have

40 seconds to use the keypad (Item 3) [Figure SA-1] to

enter each digit of a new four-digit password.

Enter the new four-digit password. After the fourth digit is

entered, there will be two short beeps and rPEAt will

appear.

Re-enter the new four-digit password to verify. If the new

passwords match, there will be two short beeps, Code will

appear for 1 second and then the LCD will return to

HOURMETER function.

NOTE: If the new passwords do not

match, there will

be one long beep and Error will appear for

1 second and then the LCD will return to

HOURMETER function.

B-15819

1 2 ... 111 112 113 114 115 116 117 118 119 120 121 ... 136 137

Commentaires sur ces manuels

Pas de commentaire

Bobcat 328 - S/N 234211001 Instructions d'exploitation Page 116

Commentaires sur ces manuels

Produits connexes et manuels pour Pelleteuse Bobcat 328 - S/N 234211001